Buying online Freud 98-509 2 Piece Crown Molding Bit Set - 99-416 and 99-415 1/2 inch shank

Freud 98-509

I used these bits to route a profile on a 5" high square base frame for a rotating bookshelf. I started with planed stock in both width and thickness. It was imperative to have stock that was the same width to allow the profiles to line up once the ends were mitred. Before each pass, I adjusted the fence and feather boards. It was very important to use double feather boards on the table and to have two f/b's attached to the table's fence. With this setup, I only had to push the boards from the end...no hand support around the bit. The finished product was very good. I had minor areas where the two bits left a line, but ... Use Freud's Molding Bevel Cutter 99-421 Freud 98-509 to rout perfect 38 Freud 98-509 and 52 degree bevels on the stock to finish the job Freud 98-509 Freud's Limited Lifetime Freud 98-509 Guarantee ... »» Read more...

» Check Price.